|
Makita 784810-A-A 4-5/8-Inch Bit Tip Holder and 3-1/8-Inch Bit Tip Holder with #2 Phillips Bit Tip and Slotted Bit Tip
|
MSRP: $17.50
Your Price: $15.61
Savings: $ 1.89 ( 11% )
Shipping: Usually ships in 2 to 4 weeks
Manufacturer: Makita
|
|
Makita 784810-A-A 4-5/8-Inch Bit Tip Holder and 3-1/8-Inch Bit Tip Holder with #2 Phillips Bit Tip and Slotted Bit Tip Features
|
For use with electric or cordless driver-drills
Prevents screws from wobbling while inserting or removing
Uses standard Phillips and slotted insert bits
Set includes 1 "Shorty" and 1 "Original" finder/driver, 1 regular finder/driver, and 5 insert bits
Overall lengths are 3-1/8-inches and 4-5/8-inches without bit
|
|
|
|
|
|
|
|
|
Additional Makita 784810-A-A 4-5/8-Inch Bit Tip Holder and 3-1/8-Inch Bit Tip Holder with #2 Phillips Bit Tip and Slotted Bit Tip Information
|
A "must have" for every contractor and/or do-it-yourselfer. Excellent control for inserting and extracting screws. This set includes: one "Shorty" and one "Original" finder/driver, one regular finder/driver and five insert bits.
|
|
|
What Customers Say About Makita 784810-A-A 4-5/8-Inch Bit Tip Holder and 3-1/8-Inch Bit Tip Holder with #2 Phillips Bit Tip and Slotted Bit Tip:
|
|
These are fantastic and work great, they are everything I expect from a makita product. It's great having two now that I use multiple guns and don't have to switch them all the time, and the different lengths are helpful as well.
I got these and the magnet is so strong it even affects my nut drivers some, saving me from having to go buy really expensive magnetic sockets. I've gone through a few of these lately looking for one with a good magnet. It pulls bits in hard also so they don't get pulled out when you're in the middle of a job. I install car radios and dropping screws is such a pain and time waster. My Black and Decker tip holder and my Dewalt tip holder don't do a very good job, and the sleeves tend to slip down a lot. If you have a Makita drill go ahead and drop the money on these. My 9.6v Makita drill's chuck is pretty shallow, so these fit much better than other brands or no name ones that come with bit sets.
What I Really Needed Istalling Cabinets Was the 3 1/8 Holder.Both Are Nice With Sleeves That Don't Spin With The Holder.
|
|
 |
|
|
